Weiss ADC2 A/D-FW - Converter mit Firewireanschluss

The ADC2-FW is the ADC2 with Firewire Option


The firewire option is a PCB which plugs into the main board of the ADC2. It supports bidirectional transmission:

- analog or digital in from the ADC2 to the computer

- from the computer to the ADC2, out on the S/PDIF connector on the back.

All sampling rates are supported. There are drivers for Windows and for PowerPC or Intel based MACs available.




The ADC2-FW uses state of the art A/D chips in our proven ?correlation technique? configuration, which lowers converter imperfections.

The analog input stages are kept balanced from the input connectors throughout to the converter chips. A high quality microphone preamplifier is built in as a standard feature.

Supported sampling frequencies are 44.1, 48, 88.2, 96, 176.4 and 192 kHz.

Output formats are AES/EBU in one or two wire technique, S/PDIF as well as Firewire for a direct connection to computers.

Synchronization can be internal or external through AES/EBU or BNC (Wordclock).

The built in digital peak limiter allows for setting a generous headroom on the analog inputs and still get a full scale signal at the converter?s output.

A large bar graph shows the level to the A/D input, the output level and the gain reduction in the aforementioned Limiter.

The output wordlength can be reduced from 24 to 16 bits with the built in POW-R dithering. It is even possible to have one output running at 24 bits and another one at 16 bits. This feature comes handy when a safety copy to e.g. a DAT has to be made.

The analog input sensitivity can be set in 1dB steps via a relais controlled attenuator. An additional gain control is implemented in the DSP chip in the digital domain.

Both channel 1 and channel 2 are fully independent, except for the sampling rate and for the dither settings.

The AES/EBU sync input can be used as a digital audio input. This allows to limit and / or dither digital audio signals. The peak hold feature can be used to monitor a transfer and check for overloads which may have occured.

The ADC2 uses state of the art A/D chips in our proven ?correlation technique? configuration, which lowers converter imperfections.The analog input stages are kept balanced from the input connectors throughout to the converter chips. A high quality microphone preamplifier is built in as a standard feature.Supported sampling frequencies are 44.1, 48, 88.2, 96, 176.4 and 192 kHz.Output formats are AES/EBU in one or two wire technique, S/PDIF as well as Firewire for a direct connection to computers. Synchronization can be internal or external through AES/EBU or BNC (Wordclock).The built in digital peak limiter allows for setting a generous headroom on the analog inputs and still get a full scale signal at the converter?s output.A large bar graph shows the level to the A/D input, the output level and the gain reduction in the aforementioned Limiter.The output wordlength can be reduced from 24 to 16 bits with the built in POW-R dithering. It is even possible to have one output running at 24 bits and another one at 16 bits. This feature comes handy when a safety copy to e.g. a DAT has to be made.The analog input sensitivity can be set in 1dB steps via a relais controlled attenuator. An additional gain control is implemented in the DSP chip in the digital domain.Both channel 1 and channel 2 are fully independent, except for the sampling rate and for the dither settings.The AES/EBU sync input can be used as a digital audio input. This allows to limit and / or dither digital audio signals. The peak hold feature can be used to monitor a transfer and check for overloads which may have occured.